Hyundai Santa Fe (TM): Steering System / Special service tools

Special Service Tools
Tool (Number and Name)
IIIustration
Use
09568-2J100
Ball joint remover

Tie rod end ball joint removal
09568-4R100
Ball joint remover

Lower arm ball joint removal

    Specifications Item Specification Type Electric Power Steering System Steering gear Type Rack & Pinion Rack stroke 152 ± 1 mm(5.

    Troubleshooting Symptom Probable cause Remedy Play in steering Loose yoke plug Retighten Loose steering gear mounting bolts Retighten Loose or worn tie rod end Retighten or replace as necessary Steering wheel does not return properly Excessive turning resistance of tie rod end Replace Yoke plug excessively tight Adjust Tie rod and/or ball joint cannot turn smoothly Replace Loose mounting of gear box mounting bracket Worn steering shaft joint and/or Retighten Worn steering shaft joint and / or body grommet Correct or replace Distorted rack Replace Damaged pinion bearing Replace Twisted or damaged hoses Reposition or replace Damaged oil pressure control valve Replace Damaged oil pump input shaft bearing Replace Rattling or chucking noise in the rack and pinion Interference with hoses from vehicle body Reposition Loose gear box bracket Retighten Loose tie rod end and / or ball joint Retighten Worn tie rod and / or ball joint Replace

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: PTC Heater (Diesel only). Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the mode to FLOOR. (2) Set the temperature to MAX HOT.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Power Mosfet. Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until it reaches high speed.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0152