Hyundai Santa Fe: Automatic Transaxle System (SBC) / Special service tools

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Automatic Transaxle System (SBC) / Special service tools

Special Service Tools
Tool
(Number and Name)
Illustration
Use
09200-3N000
Engine support fixture
(Beam)

Removal and installation of the transaxle.Use this beam (SST No. : 09200-3N000) with the supporter (SST No. : 09200-L1100, 09200-L1200) and Adapter (SST No. : 09200-2W000).
09200-L1100
Engine support fixture (Rear)

Removal and installation of the transaxle.with the beam (SST No. : 09200-38001/3N000).
09200-L1200
Engine support fixture (Front)

Removal and installation of the transaxle.with the beam (SST No. : 09200-38001/3N000).
09200-2W000
Adapter

Removal and installation of the transaxle.with the beam (SST No. : 09200-38001/3N000).
09453-3L241
Oil seal installer

Installation of the differential oil seal in the transaxle case and housing side (2WD).[Using with bar (SST No.09231-H1100)]
Oil seal installer
09453-2W100

4WD : Installation of the differential oil seal in the housing side
[Using with bar (SST No.:09231-H1100)]
09231-H1100
Handle

Installation of the differential oil seal in the transaxle case and housing side.[Using with oil seal installer (SST No.:09452-26100)]
09480-A3800
Position switch neutral fixed pin

When installing the manual control lever on the inhibitor switch, used to align the neutral position.

    Specifications

    Specifications Item Specifications Engine type Gasoline 2.5 MPI Automatic transaxle type FF 6th Automatic transaxle (A6MF2-2) Drive type 2WD / 4WD Gear ratio 1st 4...

    Automatic Transaxle System

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Transaxle Control Module (TCM). Repair procedures


    Inspection 1. TCM ground circuit test : Measure the resistance between TCM and chassis ground. (Inspect the terminal connected to the chassis ground with the back of harness connector as the inspection point of TCM side...

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Photo Sensor. Repair procedures


    Inspection 1. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 2. The voltage will rise with higher intensive light and reduce with lower intensive light...

    Categories

    Engine oil pressure warning light. Low fuel level warning light

    Engine oil pressure warning light

    This warning light illuminates:

    When the engine oil pressure is low.

    If the engine oil pressure is low:

    1. Drive carefully to the nearest safe location and stop your vehicle.

    2. Turn the engine off and check the engine oil level (For more details, refer to “Engine Oil” section in chapter 9). If the level is low, add oil as required.

    read more


     
    Copyright © 2025 www.hsafe4.com