Hyundai Santa Fe: Cooling System / Reservoir Tank. Repair procedures
1. |
Remove the reservoir tank.
(1) |
Disconnect the water hose (A).
|
(2) |
Disconnect the degassing hose (B).
|
(3) |
Remove the reservoir tank (C).
Tightening torque :
7.8 - 11.7 N.m (0.8 - 1.2 kgf.m, 5.7 - 8.6 Ib-ft)
|
|
|
2. |
Install in the reverse order of removal.
|
Removal and Installation
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Removal and Installation
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Other information:
Removal
•
In order to remove rear glass, use tools as follows shown in
the picture.
[Tools block diagram]
① Square wire
② Insert type wire grip
[Tools assembly diagram]
•
Tighten square wire ① inserting it in the hole of Insert type
wire grip ②
1...
Component Location
1. Windshield
wiper arm & blade
2. Wiper & washer switch
3. Windshield washer hose
4. Windshield wiper motor & linkage
5. Washer motor
6. Washer reservoir
7. Front wiper relay (Engine room relay box)
8...
Categories
1. Driver’s front air bag
2. Passenger’s front air bag
3. Side air bag
4. Curtain air bag
The vehicles are equipped with a Supplemental Air Bag System for the driver’s
seat and front passenger’s seats.
The front air bags are designed to supplement the three-point seat belts. For
these air bags to provide protection, the seat belts must be worn at all times when
driving.
read more