Hyundai Santa Fe: 4WD Control System / Repair procedures
The friction material inside the coupling will degrade over time. Therefore,
corresponding compensation values must be referenced and entered after replacing
the controller or the coupling.
Compensation Requirement and Procedure
1. |
Simultaneous replacement of 4WD ECU (Controller) and coupling
–
|
Does not require compensation.
|
|
2. |
Replacement of coupling only
–
|
Reset the 4WD ECU's (Controller) clutch learning.
|




|
3. |
Replacement of 4WD ECU (Controller) only
–
|
Before replacement: Check the ECU's clutch learning.










|
–
|
After replacement: Enter the original ECU's clutch learning
into the replacement ECU.








|
–
|
Perform the following procedure in case of the appearance of
failure code (P182900, P183600).



|
|
Description
The AWD ECU distributes the driving force to the front/rear wheel through controlling
the multi plate clutch on the AWD transfer case by analyzing the input information,
i...
Other information:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Disconnect the 6P connector (B) of the coil antenna and then remove
the coil antenna (A) after loosening the screw...
..
Categories
Speedometer
.png)
The speedometer indicates the speed of the vehicle and is calibrated in miles
per hour (MPH) and/or kilometers per hour (km/h).
Tachometer
.png)
read more