Hyundai Santa Fe: Cylinder Block / Piston and Connecting Rod. Components and components location

1. Piston ring
2. Snap ring
3. Piston
4. Connecting rod
|
5. Connecting
rod upper bearing
6. Connecting rod lower bearing
7. Connecting rod bearing cap
|
Removal
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Disassembly
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Other information:
[A] : LOCK, [B] : ACC, [C] : ON, [D] : START
Whenever the front door is opened, the ignition switch will illuminate, provided
the ignition switch is not in the ON position. The light will go off immediately
when the ignition switch is turned on or go off after about 30 seconds when the
door is closed...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
3.
Remove the tail gate latch and PCU (A) after loosening the mounting
bolts...
Categories
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air
bags or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If
the location or angle of the sensors is altered, the air bags may deploy when
they should not or may not deploy when they should.
Installing bumper guards with nongenuine Hyundai or non-equivalent
parts may adversely affect the collision and airbag deployment performance.
Press the Engine Start/Stop button to the OFF or ACC position and
wait for 3 minutes when the vehicle is being towed to prevent inadvertent air
bag deployment.
Have all air bag repairs performed by an authorized HYUNDAI dealer.
read more