Hyundai Santa Fe: Lubrication System / Oil Level Gauge & Pipe. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Engine Mechanical System / Lubrication System / Oil Level Gauge & Pipe. Repair procedures

Removal and Installation

•	Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift. (Refer to General Information - "Lift and Support Points")

1.	Remove the oil level gauge (A).

2.	Remove the timing chain cover. (Refer to Timing System - "Timing Chain Cover")

Remove the oil level pipe (A).

Tightening torque :

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

4.	Install in the reverse order of removal.

Oil Pressure Switch. Repair procedures

Removal and Installation • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift...

Oil Filter & Oil Cooler. Repair procedures

Removal and Installation • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Intake Air Temperature Sensor (IATS). Description and operation

Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of the air temperature is needed because air density varies according to the temperature...

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Variable Intake Solenoid (VIS) Valve. Description and operation

Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or closes this valve according to engine condition (Refer to below table)...