Hyundai Santa Fe: Heater / Mode Control Actuator. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Heating,Ventilation And Air Conditioning / Heater / Mode Control Actuator. Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the mode control actuator connector.

Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 7.

Verify that the mode control actuator operates to the vent mode when connected in reverse.

1. -
2. -
3. Defrost mode
4. Sensor ground

5. Feedback signal
6. Sensor (5V)
7. Vent mode

4.	Connect the mode control actuator connector.

5.	Turn the ignition switch ON.

Check the voltage between terminal 5 and 4.

Specification

Door position	Voltage (V)	Error detecting
Vent	0.3 ± 0.15	Low voltage : 0.1V or less High voltage : 4.9V or less
Defrost	4.7 ± 0.15	Low voltage : 0.1V or less High voltage : 4.9V or less

It will feedback the current position of the actuator to controls.

7.	If the measured voltage is not within specification, substitute with a known-good mode control actuator and check for proper operation.

8.	Replace the mode control actuator if it is proved that there is a problem with it.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly")

3.	Separate the mode control actuator connector (B) and loosen the mounting screw and remove the mode control actuator (A).

4.	Install in the reverse order of removal.

Mode Control Actuator. Components and components location

Auto Defogging Actuator. Description and operation

Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Specifications

Specifications Smart Key Unit Items Specification Rated voltage DC 12V Operating voltage DC 9 - 16V Operating temperature -22°F to 167°F (-30°C to- 75°C) Load Max...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Overdrive Clutch Control Solenoid Valve (OD/C_VFS). Description and operation

Description • Overdrive clutch control solenoid valve(OD/C_VFS) is attached to the valve body. • This variable force solenoid valve directly controls the hydraulic pressure inside the overdrive clutch...