Hyundai Santa Fe: Heater / Mode Control Actuator. Description and operation
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control actuator
based on the signal of the A/C control unit. Pressing the mode select switch
makes the mode control actuator shift in order of Vent → Bi-Level → Floor →
Mix.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector...
Other information:
Forward Safety warning light
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The Forward Safety warning light illuminates for approximately 3 seconds and
then goes off.
Whenever there is a malfunction with Forward Collision-Avoidance Assist...
To install a LATCH-compatible Child Restraint System in either of the rear outboard
seating positions:
1. Move the seat belt buckle away from the lower anchors.
2. Move any other objects away from the anchorages that could prevent a secure
connection between the Child Restraint System and the lower anchors...
Categories

The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
read more