Hyundai Santa Fe: Ignition switch / Key ignition switch

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual / Driving your vehicle / Ignition switch / Key ignition switch

[A] : LOCK, [B] : ACC, [C] : ON, [D] : START

Whenever the front door is opened, the ignition switch will illuminate, provided the ignition switch is not in the ON position. The light will go off immediately when the ignition switch is turned on or go off after about 30 seconds when the door is closed. (if equipped)

WARNING

  • NEVER turn the ignition switch to the LOCK or ACC position while the vehicle is in motion except in an emergency. This will result in the engine turning off and loss of power assist for the steering and brake systems. This may lead to loss of directional control and braking function, which could cause an accident.
  • Before leaving the driver's seat, always make sure the shift button is in 1st gear (for manual transmission vehicle) or P (Park, for automatic transmission vehicle) position, apply the parking brake, and turn the ignition switch to the LOCK position. Unexpected vehicle movement may occur if these precautions are not followed.

NOTICE

Never use after market keyhole covers. This may generate start-up failure due to communication failure.

    Ignition switch

    WARNING To reduce the risk of SERIOUS INJURY or DEATH, take the following precautions: NEVER allow children or any person who is unfamiliar with the vehicle to touch the ignition switch or related parts...

    Key ignition switch positions

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2024 Service Manual: Luggage Side Trim. Repair procedures


    Replacement    • Put on gloves to prevent hand injuries.    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

    Hyundai Santa Fe (TM) 2019-2024 Service Manual: Emergency Signal System. Description and operation


    Description Introduction of quick brake warning system (ESS) In case of quick brake by driver, the brake lamp or turn signal is blinked to warn against the vehicle at rear. 1. Basic function (Blinking the brake lamp/emergency lamp) – Operation condition : In case of quick brake or operation of ABS above in a certain speed – Releasing condition : In case of stopping the quick brake or releasing the ABS operation 2...

    Categories

    Instrument panel overview

    1. Instrument cluster
    2. Driver’s front air bag
    3. Engine Start/Stop button
    4. Infotainment system
    5. Hazard warning lamp switch
    6. Climate control system
    7. Shift button
    8. ISG (Idle Stop and Go) button
    9. Auto Hold button
    10. Heated steering wheel button
    11. Drive mode button
    12. DBC (Downhill Brake Control) button
    13. Parking Safety button
    14. Parking/View button
    15. Air ventilation seat button
    16. Seat warmer
    17. Passenger’s front air bag
    18. Glove box
    19. Wireless charging system pad
    20. Cup holder
    21. AC inverter
    22. USB charger

    read more


     
    Copyright © 2024 www.hsafe4.com