Hyundai Santa Fe: Heater / Heater Unit. Components and components location


1. Heater
unit assembly
2. Heater NVH pad
3. Heater seal duct
4. Heater tube cover
5. Heater core assembly
6. Tempearture control actuator (Single)
7. Mode control actuator
8. Heater case [LH]
|
9. Heater
divider plate
10. DEF door assembly
11. Heater case [RH]
12. Auto defogging actuator
13. Temperature control actuator (Dual)
14. PTC heater
15. VENT door assembly
16. Floor door assembly
|
17. Mode
door assembly
18. Temperature door shaft
19. Temperature door assembly
20. Heater drain fan
21. Drain hose assembly
22. Aspirator hose
23. Evaporator core assembly
24. Evaporator temperature sensor
|
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station...
Other information:
The engine is automatically restarted in the following situations.
The brake vacuum pressure is low
The engine has stopped for about 5 minutes
The air conditioning is ON with the fan speed set to a certain high
level
The front defroster is ON
The battery is weak
The cooling and heating performance of the climate control system is
unsatisfactory
The vehicle is shifted to P (Park) or R (Reverse) when Auto Hold is
activated
The door is opened or the seatbelt is unfastened when Auto Hold is
activated
The EPB switch is pressed when Auto Hold is activated
The Auto Stop () indicator blinks
in green for 5 seconds on the instrument cluster when the engine is restarted...
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and
is installed on the surge tank. It senses absolute pressure of the surge tank
and transfers the analog signal proportional to the pressure to the ECM...
Categories
Speedometer
.png)
The speedometer indicates the speed of the vehicle and is calibrated in miles
per hour (MPH) and/or kilometers per hour (km/h).
Tachometer
.png)
read more