Hyundai Santa Fe: Fuses / Fuse/relay panel description

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual / Maintenance / Fuses / Fuse/relay panel description

Instrument panel fuse panel

Inside the fuse/relay box cover, you can find the fuse/relay label describing fuse/ relay names and ratings.

Information

Not all fuse panel descriptions in this manual may be applicable to your vehicle; the information is accurate at the time of printing. When you inspect the fuse box on your vehicle, refer to the fuse box label.

Instrument panel fuse panel

Engine compartment fuse panel (Engine room junction block)

Inside the fuse/relay box cover, you can find the fuse/relay label describing fuse/ relay names and ratings.

Information

Not all fuse panel descriptions in this manual may be applicable to your vehicle; the information is accurate at the time of printing. When you inspect the fuse panel in your vehicle, refer to the fuse panel label.

Engine compartment fuse panel (Engine room junction block)

Engine compartment fuse panel (PCB block)

Engine compartment panel fuse replacement

Blade fuse / Cartridge fuse 1. Turn the vehicle off. 2. Turn all other switches off. 3. Remove the fuse panel cover by pressing the tap and pulling up...

Light bulbs

We recommend that you consult an authorized HYUNDAI dealer to replace most vehicle light bulbs. It is difficult to replace vehicle light bulbs because other parts of the vehicle must be removed before you can get to the bulb...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: External Amplifier. Repair procedures

Removal External Amplifier 1. Disconnect the negative (-) battery terminal. 2. Remove the passenger seat assembly. (Refer to Body - "Front Seat Assembly") 3...

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Check tire pressure

You can check the tire pressure in the Warning mode on the cluster. Refer to the “LCD Display Modes” in chapter 4. Tire pressure is displayed after a few minutes of driving after initial engine start up. If tire pressure is not displayed when the vehicle is stopped, “Drive to display” message will appear...