Hyundai Santa Fe: Seat Belt Pretensioner / Emergency Fastening Device (EFD). Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD). Repair procedures

Removal

1.	Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.

2.	Remove the anchor seat belt (A).

3.	Remove the front seat. (Refer to Body - "Front Seat")

4.	Remove the door scuff trim trim. (Refer to Body - "Door Scuff Trim")

5.	Remove the center pillar lower trim. (Refer to Body - "Center Pillar Trim")

6.	Disconnect the connector (A) and then remove the anchor pretensioner by loosening the mounting bolt.

Installation

Install anchor pretensioner and reconnect the connector (A).

Tightening torque :

39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

2.	Remove the front seat. (Refer to Body - "Front Seat")

3.	Install the center pillar lower trim. (Refer to Body - "Center Pillar Trim")

4.	Install the door scuff trim trim. (Refer to Body - "Door Scuff Trim")

Reconnect the battery negative cable.

After installing the anchor pretensioner, confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Emergency Fastening Device (EFD). Components and components location

Brake System

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Rear Washer Switch. Repair procedures

Inspection 1. Check for continuity between the terminals in each switch position as shown below. Switch Switch position Switch terminal Resistance (Ω, ±3...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Emergency Signal System. Description and operation

Description Introduction of quick brake warning system (ESS) In case of quick brake by driver, the brake lamp or turn signal is blinked to warn against the vehicle at rear. 1. Basic function (Blinking the brake lamp/emergency lamp) – Operation condition : In case of quick brake or operation of ABS above in a certain speed – Releasing condition : In case of stopping the quick brake or releasing the ABS operation 2...