Hyundai Santa Fe: Maintenance / Cabin air filter

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual / Maintenance / Cabin air filter

Filter inspection

The cabin air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely airpolluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced sooner. Replace the cabin air filter by following the procedure below and be careful to avoid damaging other components.

Filter replacement

1. Open the glove box and remove the support rod (1).

2. Remove the stoppers on both sides to allow the glove box to hang freely on the hinges.

3. Press and hold the lock on the right side of the cover.

4. Pull out the cover.

5. Replace the cabin air filter.

6. Reassemble in the reverse order of disassembly.

NOTICE

Install a new cabin air filter in the correct direction with the arrow symbol (↓) facing downwards, to prevent noise and improve effectiveness.

Air cleaner

Filter replacement The air cleaner filter can be cleaned for inspection using compressed air. Do not attempt to wash or to rinse it, as water will damage the filter...

Wiper blades

Blade inspection Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Compressor. Description and operation

Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas...

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Air intake control

This is used to select the outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button. Recirculated air position With the recirculated air position selected, air from the passenger compartment will be drawn through the heating system and heated or cooled according to the function selected...