| Components Location |

| 1. Blower unit
assembly |
| Components |

| 1. Blower unit
assembly 2. Inlet case [LH] 3. Inlet seal 4. Inlet case [RH] 5. Intake actuator 6. Inlet door assembly 7. Blower NVH pad 8. Blower upper case |
9. Climate control
actuator 10. Air filter cover 11. Blower divider plate 12. Blower resistor (Manual) 13. Power mosfet (DATC) 14. Blower lower case 15. Blower lower cover 16. Blower motor assembly |
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station.
Troubleshooting 1) After replacing controller, always check that the system operates properly. 2) If the failure persists after replacing the controller, do not replace th