Hyundai Santa Fe: Auto Hold / Warning messages

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual / Driving your vehicle / Braking system / Auto Hold / Warning messages

Parking brake automatically engaged / Parking brake automatically applied

When EPB is applied while Auto Hold is activated, a warning will sound and a message will appear.

Deactivating AUTO HOLD... Press brake pedal

When the conversion from Auto Hold to EPB is not working properly a warning will sound and a message will appear.

When this message is displayed, Auto Hold and EPB may not operate. For your safety, depress the brake pedal.

Press brake pedal to deactivate AUTO HOLD

If you did not apply the brake pedal when you release Auto Hold by pressing the AUTO HOLD switch, a warning will sound and a message will appear.

AUTO HOLD conditions not met. Close door, hood and liftgate.

When you press the AUTO HOLD switch, if the driver's door and engine hood are not closed, a warning will sound and a message will appear on the cluster LCD display.

Press the AUTO HOLD switch after closing the driver's door and hood.

Auto Hold

Auto Hold maintains the vehicle in a standstill even though the brake pedal is not depressed after the driver brings the vehicle to a complete stop by depressing the brake pedal...

Anti-lock Brake System (ABS)

WARNING Anti-Lock Braking System (ABS) or Electronic Stability Control (ESC) system will not prevent accidents due to improper or dangerous driving maneuvers...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Troubleshooting

Basic Troubleshooting Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The measured resistance at high temperature after vehicle running may be high or low...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Side Impact Sensor (SIS). Repair procedures

Removal • Removal of the airbag must be performed according to the precautions/procedures described previously. • Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor...