Hyundai Santa Fe: Brake System / Vacuum Pump. Repair procedures
[G 2.5 T-GDI THETA III (Only)]
1. |
Disconnect the batter ( - ) cable.
|
2. |
Remove the retaining clip then remove the vacuum pump hose (A).
|
3. |
Remove the vacuum pump connector (A).
|
4. |
Remove the bolts, then remove the vacuum pump assembly (A).
Tightening torque :
19.6 - 24.5 N·m (2.0 - 2.5 kgf·m, 14.5 - 18.1 lb·ft)
|
|
1. |
Install in the reverse order of removal
|
Removal
1.
Turm ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the battery...
Other information:
Adjustment
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the lower crash pad.
(Refer to Body - "Crash Pad")
3...
Replacement
[Tailgate lower trim]
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Categories
The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
read more