Hyundai Santa Fe (TM): Electronic Parking Brake (EPB) / Warning messages

To release EPB, fasten seatbelt and close door, hood and liftgate
- If you try to drive with EPB applied, a warning will sound and a message
will appear.
- If the driver's seat belt is unfastened and the engine hood or liftgate
is opened, a warning will sound and a message will appear.
- If there is a problem with the vehicle, a warning may sound and a message
may appear.
If the situation occurs, depress the brake pedal and release EPB by pressing
the EPB switch.
WARNING
- Whenever leaving the vehicle or parking, always come to a complete
stop and continue to depress the brake pedal.
Shift the gear into P (Park), pull up the EPB switch, and press the Engine Start/Stop
button to the OFF position. Take the Key with you when leaving the vehicle.
Vehicles not fully engaged in P (Park) with the parking brake set are at risk
for moving inadvertently and causing injury to yourself or others.
- NEVER allow anyone who is unfamiliar with the vehicle to touch the
EPB switch. If EPB is released unintentionally, serious injury may occur.
- Only release EPB when you are seated inside the vehicle with your
foot firmly on the brake pedal.
NOTICE
- Do not apply the accelerator pedal while the parking brake is engaged.
If you depress the accelerator pedal with EPB engaged, a warning will sound
and a message will appear. Damage to the parking brake may occur.
- Driving with the parking brake on can overheat the braking system
and cause premature wear or damage to brake parts. Make sure EPB is released
and the Parking Brake warning light is off before driving.
Information
- A clicking sound may be heard while operating or releasing the EPB.
These conditions are normal and indicate that EPB is functioning properly.
- When leaving your keys with a parking attendant or assistant, make
sure to inform him/her how to operate EPB.
AUTO HOLD turning Off! Press brake pedal

When the conversion from Auto Hold to EPB is not working properly a warning will
sound and a message will appear.
Parking brake automatically engaged

When EPB is applied while Auto Hold is activated, a warning will sound and a
message will appear.
To release EPB (Electronic Parking Brake):
1. Press the Engine Start/Stop button to the ON or START position.
2. Press the EPB switch while depressing the brake pedal.
Electronic Parking Brake (EPB) warning light illuminates if the Engine Start/Stop
button is pressed to the ON position and goes off in approximately 3 seconds if
the system is operating normally.
Other information:
Description
Surround View Monitor (SVM) is the system that allows video monitoring of 360
degrees around the vehicle. The system includes 4 ultra optical camera mounted
around the vehicle (front, both sides, rear).
The video from these cameras are applied with distortion compensation, time
point conversion, and video me
Troubleshooting
Diagnosis with Diagnostic tool
1.
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (Diagnostic tool).
The diagnostic system (Diagnostic tool) provides the following information.