Hyundai Santa Fe (TM): Infotainment system / Antenna

Shark fin antenna

The shark fin antenna receives transmitted data. (for example: AM/FM, DAB, GPS)

Steering wheel remote controls

NOTICE

Do not operate multiple audio remote control buttons simultaneously.

VOLUME (VOL + / VOL -) (1)

  • Rotate the VOLUME scroll up to increase volume.
  • Rotate the VOLUME scroll down to decrease volume.

SEEK/PRESET (˄/˅) (2)

If the SEEK/PRESET switch is pressed up or down and held for 0.8 second or more, it will function in the following modes:

  • RADIO mode

It will function as the AUTO SEEK select button. It will SEEK until you release the button.

  • MEDIA mode

It will function as the FF/RW button.

If the SEEK/PRESET switch is pressed up or down, it will function in the following modes:

  • RADIO mode

It will function as the PRESET STATION UP/DOWN button.

  • MEDIA mode

It will function as the TRACK UP/ DOWN button.

MODE (3)

Press the MODE button to toggle through Radio or Media modes.

MUTE ( ) (4)

  • Press the MUTE button to mute the sound.
  • Press the MUTE button again to activate the sound.

Information

See additional information in supplied Infotainment Manual.

    You can use an USB cable to connect audio devices to the vehicle USB port. Information When using a portable audio device connected to the power outlet, noise may occur during playback.

    Infotainment system For detailed information, refer to the separately supplied infotainment system manual. Voice recognition For detailed information, refer to the separately supplied infotainment system manual.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Heater Core. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit") 3. Loosen the mounting screws and remove the heater core cover (A).

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Heater & A/C Control Unit (DATC). Repair procedures

    Self Diagnosis 1. Self-diagnosis process.    • When operating the self-diagnostics, the below fault(self-diagnostics code) will blink at 0.

     
    Copyright © 2025 www.hsafe4.com - 0.0121