Hyundai Santa Fe: SRSCM / SRS Control Module (SRSCM). Description and operation
The primary purpose of the SRSCM (Supplemental Restraints System Control Module)
is to discriminate between an event that warrants restraint system deployment
and an event that does not. The SRSCM must decide whether to deploy the restraint
system or not. After determining that pretensioners and/or airbag deployment
is required, the SRSCM must supply sufficient power to the pretensioners and
airbag igniters to initiate deployment.
The SRSCM determines that an impact may require deployment of the pretensioners
and airbags from data obtained from impact sensors and other components in conjunction
with a safing function.
The SRSCM will not be ready to detect a crash or to activate the restraint system
devices until the signals in the SRSCM circuitry is stabilized.
It is possible that the SRSCM could activate the safety restraint devices in
approximately 2 seconds but is guaranteed to fully function after prove-out
is completed.
The SRSCM must perform a diagnostic routine and light a system readiness indicator
when the ignition switch is in the ON position. The system must perform a continuous
diagnostic routine and provide fault notice through a warning lamp indicator
in the event of fault detection. A serial diagnostic communication interface
will be used to facilitate servicing of the restraint control system.
Other information:
It may sometimes be difficult to read information on the Head-Up Display
in the following situations.
- The driver is improperly positioned in the driver’s seat
- The driver wears polarizing-filter sunglasses
- An object is located above the head-up display cover
- The vehicle is driven on a wet road
- Any improper lighting accessory is installed inside the vehicle, or there
is incoming light from outside of the vehicle
- The driver wears glasses
- The driver wears contact lenses
When it is difficult to read the Head- Up Display information, adjust the image
height or brightness level from the Settings menu in the infotainment system
screen...
Forward Safety warning light
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The Forward Safety warning light illuminates for approximately 3 seconds and
then goes off.
Whenever there is a malfunction with Forward Collision-Avoidance Assist...
Categories
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
WARNING
NEVER allow children in the vehicle unattended. The power seats are operable
when the vehicle is turned off.
read more