Hyundai Santa Fe: Wipers and washers / Rear window wiper and washer
.png)
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer.
HI – High wiper speed
LO – Low wiper speed
OFF – Off
.png)
Push the lever away from you to spray rear washer fluid and to run the rear wipers 1~3 cycles. The spray and wiper operation will continue until you release the lever.
Auto rear wiper (if equipped)
The rear wiper will operate while the vehicle is in reverse with the front wiper ON by selecting the function from the Settings menu on the LCD display. Select:
- Setup -> User Settings -> Convenience -> Auto Rear Wiper (in R)
Front windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles. The spray and wiper operation will
continue until you release the lever...
Manual climate control system
1. Fan speed control knob
2. Temperature control knob
3. Mode selection button
4. Front windshield defroster button
5. Rear window defroster button
6...
Other information:
Hyundai Santa Fe (TM) 2019-2024 Service Manual: Description and operation
Description TREAD Lamp – Tire Under Inflation / Leak Warning. 1. Turn on condition – When tire pressure is below allowed threshold – When rapid leak is detected by the sensor...
Hyundai Santa Fe (TM) 2019-2024 Service Manual: Cylinder Head. Repair procedures
Removal • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift...
Categories
- Manuals Home
- 4th Generation Santa Fe Owners Manual
- 4th Generation Santa Fe Service Manual
- Rear Occupant Alert (ROA)
- Instrument cluster
- Resetting the power liftgate
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.