Hyundai Santa Fe: Automatic Transaxle Control System / Position Switch. Specifications

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Automatic Transaxle System (SBC) / Automatic Transaxle Control System / Position Switch. Specifications

Specifications
▷ Type : Combination of output signals from 4 terminals
▷ Specifications
Items
Specifications
Power supply (V)
12
Output type
Combination of output signals

    Position Switch. Troubleshooting

    Fault Diagnosis ▶ Fault Diagnosis for Symptom Major Symptom Expected Cause Items to Check and Measures Shift lever inoperable Faulty shift cable tension Adjust shift cable tension (refer to "Automatic Transaxle System – Position Switch") Faulty shift cable assembly/connection Check manual control valve assembly and re-assemble if necessary...

    Position Switch. Repair procedures

    Inspection ▶ Inspection flow of the position switch ▶ Items to check 1. Inspect DTC code. 2...

    Other information:

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Troubleshooting


    Troubleshooting Problem Symptoms Table Use the table below to help you find the cause of the problem. The numbers indicate the priority of the like cause of the problem. Check each part in order. If necessary, replace these parts...

    Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: System operation


    Operating conditions Smart Cruise Control will operate when the following conditions are satisfied. Basic function The gear is in D (Drive) The driver’s door is closed EPB (Electronic Parking Brake) is not applied Your vehicle speed is within the operating speed range -- 5~110 mph (10~180 km/h): when there is no vehicle in front -- 0~110 mph (0~180 km/h): when there is a vehicle in front ESC (Electronic Stability Control), TCS (Traction Control System) or ABS is on ESC (Electronic Stability Control), TCS (Traction Control System) or ABS is not controlling the vehicle Engine rpm is not in the red zone Forward Collision-Avoidance Assist brake control is not operating Remote Smart Parking Assist brake control is not operating Information At a stop, if there is no vehicle in front of your vehicle, the system will turn on when the brake pedal is depressed...

    Categories

    Engine oil pressure warning light. Low fuel level warning light

    Engine oil pressure warning light

    This warning light illuminates:

    When the engine oil pressure is low.

    If the engine oil pressure is low:

    1. Drive carefully to the nearest safe location and stop your vehicle.

    2. Turn the engine off and check the engine oil level (For more details, refer to “Engine Oil” section in chapter 9). If the level is low, add oil as required.

    read more


     
    Copyright © 2025 www.hsafe4.com