Hyundai Santa Fe: Engine Control System / Manifold Absolute Pressure Sensor (MAPS). Schematic diagrams

Harness Connector

Specification
Pressure (kPa)
Output Voltage (V)
20.0
0.79
46.7
1...
Inspection
1.
Connect the diagnostic tool on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON...
Other information:
Removal
1.
Make sure vehicle does not roll before setting shift lever to "N" position.
2.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
3...
Variant Coding
When you need variant coding:
–
Replace Front View Camera with a new one
※ EOL Variant Coding and calibration required for new replacement
Front View Camera Variant Coding
Front view camera variant coding makes it possible to operate functions for
each vehicle type...
Categories
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air
bags or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If
the location or angle of the sensors is altered, the air bags may deploy when
they should not or may not deploy when they should.
Installing bumper guards with nongenuine Hyundai or non-equivalent
parts may adversely affect the collision and airbag deployment performance.
Press the Engine Start/Stop button to the OFF or ACC position and
wait for 3 minutes when the vehicle is being towed to prevent inadvertent air
bag deployment.
Have all air bag repairs performed by an authorized HYUNDAI dealer.
read more