Hyundai Santa Fe: Warning and indicator lights / Malfunction Indicator Lamp (MIL). Exhaust system (GPF) warning light (for gasoline
engine)
Malfunction Indicator Lamp (MIL)
This indicator light illuminates:
- When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The malfunction indicator light illuminates for about 3 seconds and then goes
off.
- Whenever there is a malfunction with either the emission control system
or the engine or the vehicle powertrain. If this occurs, have the vehicle inspected
by an authorized HYUNDAI dealer.
NOTICE
- Driving with the Malfunction Indicator Lamp (MIL) on may cause damage
to the emission control system which could affect drivability and/or fuel economy.
- If the enhanced engine protection system becomes activated due to
lack of engine oil, engine power will be limited. If such condition continues
repeatedly, the Malfunction Indicator Lamp will illuminate.
NOTICE
If the Malfunction Indicator Lamp (MIL) illuminates, potential catalytic converter
damage is possible which could result in loss of engine power.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer
as soon as possible.
Exhaust system (GPF) warning light (for gasoline engine)
- This warning light illuminates, when accumulated soot reaches a certain
amount.
- When this warning light illuminates, it may turn off after driving
the vehicle at more than 50 mph (80km/h) for about 30 minutes (above 3rd gear
with 1500 ~ 4000 engine rpm). If this warning light blinks in spite of the procedure
(at this time LCD warning message will be displayed), have the GPF system checked
by an authorized HYUNDAI dealer.
NOTICE
If you continue to drive with the GPF warning light blinking for a long time,
the GPF system can be damaged and fuel consumption can worsen.
Engine oil pressure warning light
This warning light illuminates:
When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle...
Electronic Parking Brake (EPB) warning light
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position...
Other information:
Removal
1.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump")
2.
Disconnect the fuel sender connector (A).
3.
Release the fixing hook (A) and then remove fuel sender (B) in the arrow
direction...
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
When the engine is cool, drain the engine coolant from the radiator...
Categories
The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
read more