Hyundai Santa Fe: Driving your vehicle / Idle Stop and Go (ISG)

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual / Driving your vehicle / Idle Stop and Go (ISG)

Idle Stop and Go helps reduce fuel consumption by automatically shutting down the engine, when the vehicle is at a standstill (for example, red stop light, stop sign, and traffic jam) subject to certain prerequisite conditions being satisfied as listed below.

The engine is automatically started upon satisfying the starting conditions.

ISG system is always active, when the engine is running.

Information

When the engine is automatically started by ISG system, warning lights (for example, ABS, ESC, ESC OFF, EPS, and parking brake warning light) may illuminate for a few seconds due to low battery voltage.

However, it does not indicate a malfunction with ISG system.

Reducing the risk of a rollover

Your multi-purpose passenger vehicle is defined as a Sports Utility Vehicle (SUV). SUV’s have higher ground clearance and a narrower track to make them capable of performing in a wide variety of off-road applications...

ISG system operation

Prerequisite for activation ISG system operates in the following situations. The driver's seatbelt is fastened The driver's door and hood are closed The brake vacuum pressure is adequate The battery sensor is activated and the battery is sufficiently charged Outside temperature is not too low or too high The vehicle is driven over a constant speed and stops The climate control system satisfies the conditions The vehicle is sufficiently warmed up ISG related parts are working properly The incline is gradual The steering wheel is turned less than 180 degrees and then the vehicle stops Information If the ISG light (white) is turned on on the instrument cluster and does not meet the ISG system operating conditions, the ISG system is not activated...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: For safe 4WD operation


Before driving Make sure all passengers are wearing seat belts. Sit upright and closer to the steering wheel than usual. Adjust the steering wheel to a position comfortable for you to drive. Driving on snow-covered or icy roads Start off slowly by applying the accelerator pedal gently...

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Components and components location


Component Location 1. Lumber support motor (Vertical) 2. Lumbar support motor (Horizontal) 3. Reclining motor 4. Rear height motor 5. Front height motor 6. Slide motor 7. Power seat switch 8. Reclining switch 9...

Categories

Power adjustment

The front seat can be adjusted by using the control switches located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so that you can easily control the steering wheel, foot pedals and controls on the instrument panel.

WARNING

NEVER allow children in the vehicle unattended. The power seats are operable when the vehicle is turned off.

read more


 
Copyright © 2024 www.hsafe4.com