Hyundai Santa Fe: Warning and indicator lights / Downhill Brake Control (DBC) indicator light. AUTO STOP indicator light
Downhill Brake Control (DBC) indicator light
.png)
This indicator light illuminates:
- When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The downhill brake control indicator light illuminates for about 3 seconds and then goes off. - When you activate the system by pressing the DBC button.
This indicator light blinks:
When Downhill Brake Control system is operating.
This indicator light illuminates yellow:
Whenever there is a malfunction with Downhill Brake Control system.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
AUTO STOP indicator light
.png)
This indicator light illuminates:
When the engine enters the Idle Stop mode of ISG (Idle Stop and Go) system.
When the engine automatically starts, the AUTO STOP indicator on the cluster Illuminates to white.
For more details, refer to "ISG (Idle Stop and Go) system" section in chapter 6.
Information
When the engine automatically starts by the ISG system, some warning lights (ABS, ESC, ESC OFF, EPS or Parking brake warning light) may turn on for a few seconds. This happens because of low battery voltage. It does not mean the system has malfunctioned.
Immobilizer Indicator Light
Immobilizer Indicator Light (without smart key)
This indicator light illuminates:
When the vehicle detects the immobilizer in the key with the ignition
switch in the ON position...
Turn signal indicator light. High beam indicator light
Turn signal indicator light
This indicator light blinks:
When you operate the turn signal indicator stalk.
If any of the following occur, there may be a malfunction with the turn signal
system...
Other information:
Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Introduction
With the Tire Mobility Kit you stay mobile even after experiencing a tire puncture. The compressor and sealing compound system effectively and comfortably seals most punctures in a passenger car tire caused by nails or similar objects and reinflates the tire...
Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Parking
Always come to a complete stop and continue to depress the brake pedal. Press the P (Park) button, apply the parking brake, and place the ignition switch in the LOCK/OFF position. Take the Key with you when exiting the vehicle. WARNING When you stay in the vehicle with the engine running, be careful not to depress the accelerator pedal for a long period of time...
Categories
- Manuals Home
- 4th Generation Santa Fe Owners Manual
- 4th Generation Santa Fe Service Manual
- Brake bleeding procedures
- Smart liftgate
- Repair procedures
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.