| Inspection |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rain sensor inner cover (A) and rain sensor cover (B).
|
| 3. |
Separate the auto defogging sensor connector (A) and remove the auto
defogging sensor (A).
|
| 4. |
Install in the reverse order of removal.
|
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging.
Heater Unit. Components and components location Component Location 1. Heater Unit Assembly Components 1.
Replacement 1. Using a Lwrench, remove the cap (A) on the bottom of the receiver-drier. 2. Remove the receiver-drier (A) from condenser using a long nose plier. Check for crumbled receiver-drier and clogged bottom cap filter.
Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.