Hyundai Santa Fe (TM): SRSCM / Side Impact Sensor (SIS). Description and operation

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Restraint / SRSCM / Side Impact Sensor (SIS). Description and operation

Description
The Side Impact Sensor (SIS) system consists of two kinds of side impact sensor which are installed at each center of the front door module (left and right) and two rear sensors which are installed in the rear pillar (left and right).
•
The Front Side Impact Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.
•
The Rear Side Impact Sensor is also called A-SIS because it detects acceleration due to collision at its mounting location.
SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when collision occurrs.

    Removal    • Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

    Components 1. Gravity Side Impact Sensor [G-SIS(B-Pillar)] 2. Gravity Side Impact Sensor [G-SIS(C-Pillar)] 3.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Power Mosfet (DATC). Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Repair procedures

    Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance compensation if you do any of the following.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0139