Hyundai Santa Fe (TM): Fender / Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Fender / Repair procedures

Replacement
  
•
When removing the fender, wrap protective tape around a screwdriver or remover not to damage components
•
Put on gloves to prevent hand injuries
  
•
When removing the clips, use a clip remover.
1.
Remove the front bumper.
(Refer to Front Bumper - "Front Bumper Assembly")
2.
Loosen the mounting screws and then remove the front bumper side mounting bracket (A).
3.
Remove the fender side cover (A).
4.
Remove the DRL (Daytime Running Lights) assembly.
(Refer to Body Electrical System - "DRL (Daytime Running Lights)")
5.
Remove the front wheel guard.
(Refer to Body Side Molding - "Front Wheel Guard")
6.
Remove the fender garnish.
(Refer to Body Side Molding - "Fender Garnish.")
7.
Using a screwdriver or remover, remove the delta garnish (A).
8.
Loosen the mounting bolts remove the fender assembly (A).
Tightening torque :
(B) : 7.7 - 11.6 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
(C) : 7.8 - 10.8 N.m (0.8 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)

9.
To install, reverse removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Fender assembly

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Heater & A/C Control Unit (Manual). Components and components location

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Remote Smart Parking Assist (RSPA). Schematic diagrams

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0138