Hyundai Santa Fe (TM): Parking Brake System. Electronic Parking Brake (EPB) / Repair procedures
| Removal |
|
| 1. |
Turn ignition switch off and disconnect the battery (-) cable from the
battery.
|
| 2. |
Remove the floor console upper cover.
(Refer to Body - "Floor Console")
|
| 3. |
Disconnect the EPB switch connector (A).
|
| 4. |
Remove the EPB switch (A) after loosening the screw.
|
| 1. |
Turn ignition switch off and disconnect the battery (-) cable from the
battery.
|
| 2. |
Remove the rear wheel and tire.
|
| 3. |
Remove the EPB actuator from rear caliper.
(Refer to Brake System - "Rear Disc Brake")
|
Circuit Diagram Terminal Function Pin No Fuction Pin No Fuction 6 Electrical parking brake signal 1 2 Rear right EPB motor power 7 Electrical parking brake signal 2 3 Rear right EPB motor ground 8 Electrical parking brake signal 3 12 Rear left EPB motor ground 9 Electrical parking brake signal 4 13 Rear left EPB motor power
Other information:
Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Repair procedures
Variant Coding When you need variant coding: – Replace Front View Camera with a new one ※ EOL Variant Coding and calibration required for new replacement Front View Camera Varian
Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: General safety information and caution
General Safety Information and Caution 1. Be careful when driving the vehicle using the smart cruise control system as follows. (1) On curves or inclines/declines • The smart cruise control system may have limits