Hyundai Santa Fe (TM): Rear Heater / Rear Power Mosfet. Repair procedures

Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of the blower motor.
3.
Select the control switch to raise the voltage until it reaches high speed.

Specification
Fan
Motor Voltage
Manual
First speed
3.8 ± 0.5V
Second speed
5.0 ± 0.5V
Third speed
6.2 ± 0.5V
Fourth speed
7.4 ± 0.5V
Fifth speed
8.6 ± 0.5V
Sixth speed
9.8 ± 0.5V
Seventh speed
11.0 ± 0.5V
Eighth speed
Battery (+)

4.
If the measured voltage is not within specification, substitute with a known-good power mosfet and check for proper operation.
5.
Replace the power mosfet if it is proved that there is a problem with it.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage side trim [RH].
(Refer to Body -"Luggage Side Trim")
3.
Separate the connector and loosen the mounting screw ,remove the power mosfet (A).

4.
Install in the reverse order of removal.

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim [RH].

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Mode Control Actuator. Components and components location

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Heater & A/C Control Unit (Manual). Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the console upper cover (A). 3. Press the lock pin, separate the console upper cover connectors (A).

     
    Copyright © 2025 www.hsafe4.com - 0.0121