Hyundai Santa Fe (TM): Crash Pad / Glove Box. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Crash Pad / Glove Box. Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Open the glove box (A).
2.
Pull out the both sides stopper (B) from the glove box (A).
3.
Remove the air damper (A) from the glove box.
4.
Remove the lock pins (A) and then remove the glove box.
5.
To install, reverse removal procedure.
  
•
Replace any damaged clips (or pin - type retainers).

    Component Location 1. Glove Box

    Component Location 1. Crash pad center panel

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Evaporator Core. Repair procedures

    Replacement 1. Remove the rear heater & A/C unit. (Refer to Rear Heater - "Rear Heater Unit") 2. Loosen the mounting screws and remove the rear A/C lower case (A).

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Remote Smart Parking Assist (RSPA). Repair procedures

    Removal ADAS Parking ECU (ADAS_PRK) 1. Disconnect the negative (-) battery terminal. 2. Remove the ADAS Parking ECU (ADAS_PRK). (Refer to Advanced Driver Assistance System (ADAS) - "ADAS Parking ECU (ADAS_PRK)") Parking/View switch

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0132