Hyundai Santa Fe (TM): SRSCM / Front Impact Sensor (FIS). Description and operation

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Restraint / SRSCM / Front Impact Sensor (FIS). Description and operation

Description
The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collision. The Front Impact Sensor (FIS) sends acceleration data to the SRSCM.

    Removal 1. Turn the engine OFF. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.

    Components 1. Front impact sensor (FIS) [RH] 2. Front impact sensor (FIS) [LH]

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Temperature Control Actuator. Description and operation

    Description The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. Signal from control unit adjusts the position of the temperature door by operating the temperature switch

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Smart Cruise Control (SCC) Switch. Repair procedures

    Inspection 1. Check for resistance between terminals in left switch position. [Audio/Bluetooth] Switch Connector terminal Resistance (± 3%) SEEK Up 1 - 6 430 Ω

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0179