| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
|
| 3. |
Disconnect the eCall antenna cable and connector (A) and then remove
the antenna mounting nut.
|
| Installation |
| 1. |
Connect the eCall antenna connectors.
|
| 2. |
Install the roof trim assembly.
|
Components RADIO+GNSS+eCall RADIO+GNSS+DAB+eCall
REMOVAL 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel.
Component Location 1. Rear Heater & A/C Unit Components 1. Rear heater & blower unit assembly 2. Blower motor assembly 3. Rear power mosfet 4. Duct seal guide 5.
Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until it reaches high speed.