Hyundai Santa Fe (TM): Warning and indicator lights / Downhill Brake Control (DBC) indicator light. AUTO STOP indicator light

Hyundai Santa Fe (TM) 2019-2023 Owner's Manual / Instrument cluster / Warning and indicator lights / Downhill Brake Control (DBC) indicator light. AUTO STOP indicator light

Downhill Brake Control (DBC) indicator light

This indicator light illuminates:

  • When you set the ignition switch or the Engine Start/Stop button to the ON position.
    - The downhill brake control indicator light illuminates for about 3 seconds and then goes off.
  • When you activate the system by pressing the DBC button.

This indicator light blinks:

When Downhill Brake Control system is operating.

This indicator light illuminates yellow:

Whenever there is a malfunction with Downhill Brake Control system.

If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.

AUTO STOP indicator light

This indicator light illuminates:

When the engine enters the Idle Stop mode of ISG (Idle Stop and Go) system.

When the engine automatically starts, the AUTO STOP indicator on the cluster Illuminates to white.

For more details, refer to "ISG (Idle Stop and Go) system" section in chapter 6.

Information

When the engine automatically starts by the ISG system, some warning lights (ABS, ESC, ESC OFF, EPS or Parking brake warning light) may turn on for a few seconds. This happens because of low battery voltage. It does not mean the system has malfunctioned.

    Immobilizer Indicator Light (without smart key) This indicator light illuminates: When the vehicle detects the immobilizer in the key with the ignition switch in the ON position.

    Turn signal indicator light This indicator light blinks: When you operate the turn signal indicator stalk. If any of the following occur, there may be a malfunction with the turn signal system.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: PTC Heater (Diesel only). Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the mode to FLOOR. (2) Set the temperature to MAX HOT.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Surround View Monitor (SVM) Camera. Repair procedures

    Removal    • In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0134