Hyundai Santa Fe (TM): Body Side Molding / Door Garnish. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Body Side Molding / Door Garnish. Repair procedures

Replacement
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Put on gloves to prevent hand injuries.
1.
Using a remover or screwdriver and remove the front door garnish (A) and rear door garnish (B).
2.
To install, reverse the removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).

    Replacement    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Blower Resistor (Manual). Repair procedures

    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Front View Camera Unit. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the inside rear view mirror cover (A) and front view camera cover (B). 3.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.01