Hyundai Santa Fe (TM): Airbag Module / Curtain Airbag (CAB) Module. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module. Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the curtain airbag connector.
4.
After loosening the mounting bolts & nuts remove the curtain airbag.
Installation
1.
Turn the ignition switch OFF.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts.
Tightening torque
Bolts : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
Nuts : 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)
  
•
Never twist the airbag module when installing it. If the module is twisted, the airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

    Components 1. Curtain Airbag (CAB)

    Airbag Disposal When you scrap a vehicle equipped with an airbag, you must deploy it first. When you deploy an airbag, you need to have a skilled mechanic do the work.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Power Mosfet. Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until it reaches high speed.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Front Radar Unit. Specifications

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.014