Hyundai Santa Fe (TM): Crankcase Emission Control System / Crankcase Check Valve. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Emission Control System / Crankcase Emission Control System / Crankcase Check Valve. Repair procedures

Removal and Installation
  
•
Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
(Refer to General Information - "Lift and Support Points")
1.
Disconnect the battery (-) terminal.
2.
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the drive belt.
(Refer to Drive Belt System - "Drive Belt")
4.
Remove the compressor mounting bolts.
(Refer to Heating, Ventilation and Air Conditioning - "Compressor")
5.
Disconnect the crankcase check valve hose (A) and then remove the crankcase check valve (B).
Tightening torque :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

  
•
Push the check valve to the end of the mounting surface, and then tighten the bolt.

    Removal 1. Remove the cylinder head cover. (Refer to Engine Mechanical System - "Cylinder Head Cover") Installation 1.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Specifications

    Specifications [ADAS_PRK Application Specification (MOBIS)] Item Specification Ultrasonic sensor Voltage rating DC 12V Detecting range 40cm ~ 120cm Operating voltage DC 9V ~ 16V Operation curr

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Troubleshooting

    Troubleshooting    1) After replacing controller, always check that the system operates properly. 2) If the failure persists after replacing the controller, do not replace th

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0112