| Component Location |

| 1. Lumber support
motor (Vertical) 2. Lumbar support motor (Horizontal) 3. Reclining motor 4. Rear height motor 5. Front height motor |
6. Slide motor 7. Power seat switch 8. Reclining switch 9. Lumbar support switch |
Inspection Basic Inspection 1. Basic inspection is performed as follows. (1) Check indicator after entering self - diagnosis mod.
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.