| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the center air vent duct (A).
|
| 3. |
Remove the center speaker (A).
|
| 4. |
Remove the AVN head (A) unit after loosening mounting screws.
|
| 5. |
Remove the AVN head unit after disconnecting the connectors and cable.
|
| Installation |
| 1. |
Connect the audio unit connectors and cable.
|
| 2. |
Install the AVN head unit.
|
| 3. |
Install the center air vent duct.
|
| 4. |
Connect the negative (-) battery terminal.
|
Components Connector Pin Information No Connector A (ExternalAmplifier) Connector A (Internal Amplifier) Connector B Connector C 1 - Rear door speaker LH (+) - - 2 - Rear door speaker LH (-) Mic (+) I -CAN (High) 3 Navigation voice (+) - - - 4 External amplifier SPDIF (+) - - - 5 Reset Reset - - 6 Camera power (RVM) Camera power (RVM) Illumination (+) - 7 Camera video (RVM) Camera video (RVM) M-CAN (High) - 8 - - - - 9 - - - I -CAN (Low) 10 - - Battery (+) - 11 DETECT DETECT Battery (+) - 12 Steering wheel remote Steering wheel remote Ground - 13 - Front door speaker LH (+) - - 14 - Front door speaker LH (-) - - 15 - Front door speaker RH (-) Mic (-) - 16 - Front door speaker RH (+) - MTS 17 Navigation voice (-) - - - 18 External amplifier SPDIF (-) - - - 19 External amplifier SPDIF (Ground) - Illumination (-) - 20 Camera power_Ground (RVM) Camera power_Ground (RVM) M-CAN (Low) - 21 Camera video ground (RVM) Camera video ground (RVM) - - 22 - (SVM type:SVM video ground) - (SVM type:SVM video ground) ACC 23 - - Keyboard power 24 - - - 25 - - - 26 Steering wheel remote ground Steering wheel remote ground - 27 - Rear door speaker RH (-) - 28 - Rear door speaker RH (+) - 29 - - - 30 - - - 31 - - - 32 - (SVM type:SVM Detect1) - (SVM type:SVM Detect1) - 33 Camera video shield (RVM) Camera video shield (RVM) IGN 1 34 - (SVM type:SVM video shield ) - (SVM type:SVM video shield ) Keyboard ground 35 - - Ground 36 - - 37 - - 38 Vehicle speed Vehicle speed
Components 1. Remote control switch (LH : Audio) 2. Remote control switch (RH : Cruise+Flex)
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim [RH]. (Refer to Body - "Luggage Side Trim") 3. Separate the blower motor connector (A) and loosen the mounting screws and remove the