Auto defogging help reduce the possibility of fogging up the inside of the windshield by automatically sensing the moisture on inside the windshield.
The auto defogging system operates when the heater or air conditioning is on.
Information
The auto defogging system may not operate normally, when the outside temperature is below 14°F(-10°C).
To cancel or set the Auto Defogging System, keep the front defroster button pressed for 3 seconds. The “ADS OFF” symbol will be shown in the climate display to inform you that the system is deactivated. To re-activate the auto defogging system, follow the procedure mentioned above and the “ADS OFF” symbol will disappear.
If the battery has been disconnected or discharged, it resets to the auto defogging status.
Information
For efficiency, do not select recirculated air position while the Auto defogging system is operating.
NOTICE
Do not remove the sensor cover located on the top of the windshield glass. Damage to system parts could occur and may not be covered by your vehicle warranty.
To defog inside windshield 1. Select the desired fan speed. 2. Select the desired temperature. 3. Press the defroster button ( ). 4. The air-conditioning will turn on according to the detected ambient temperature, outside (fresh) air position and higher fan speed will be selected automatically.
NOTICE To prevent damage to the rear window defroster conducting elements bonded to the inside surface of the rear window, never use sharp instruments or window cleaners containing abrasives to clean the window.
Removal • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.