Hyundai Santa Fe: Smart Cruise Control (SCC) / System operation
Operating conditions
Smart Cruise Control will operate when the following conditions are satisfied.
Basic function
- The gear is in D (Drive)
- The driver’s door is closed
- EPB (Electronic Parking Brake) is not applied
- Your vehicle speed is within the operating speed range
-- 5~110 mph (10~180 km/h): when there is no vehicle in front
-- 0~110 mph (0~180 km/h): when there is a vehicle in front
- ESC (Electronic Stability Control), TCS (Traction Control System) or ABS
is on
- ESC (Electronic Stability Control), TCS (Traction Control System) or ABS
is not controlling the vehicle
- Engine rpm is not in the red zone
- Forward Collision-Avoidance Assist brake control is not operating
- Remote Smart Parking Assist brake control is not operating
Information
At a stop, if there is no vehicle in front of your vehicle, the system will
turn on when the brake pedal is depressed.
Overtaking Acceleration Assist
Overtaking Acceleration Assist will operate when the turn signal indicator is
turned on to the left (left-hand drive) or turned on to the right (right-hand drive)
while Smart Cruise Control is operating, and the following conditions are satisfied:
- Your vehicle speed is above 40 mph (60 km/h)
- The hazard warning flasher is off
- A vehicle is detected in front of your vehicle
- Deceleration is not needed to maintain distance with the vehicle in front
WARNING
- When the turn signal indicator is turned on to the left (left-hand
drive) or turned on to the right (righthand drive) while there is a vehicle
ahead, the vehicle may accelerate temporarily. Pay attention to the road conditions
at all times.
- Regardless of your countries driving direction, Overtaking Acceleration
Assist will operate when the conditions are satisfied. When using the function
in countries with different driving direction, always check the road conditions
at all times.
Setting functions for the system
[A] : Type A, [B] : Type B
To turn on the system
Press the Driving Assist button to turn on the system. The speed will
be set to the current speed on the cluster...
Basic function
You can see the status of the Smart Cruise Control operation in the Driving Assist
mode on the cluster. Refer to “LCD Display Modes” section in chapter 4...
Other information:
Component Location
1. Integrated
Body Control Unit (IBU)
2. Ultrasonic
Sensor
※ PDW function is applied alone, it is integrated into IBU (Integrated Body
Control Unit).
※ PDW function is applied with RSPA function, it is integrated into ADAS_PRK
controller...
'
The certification label is located on the driver's door sill at the center pillar
and shows the maximum allowable weight of the fully loaded vehicle. This is called
the GVWR (Gross Vehicle Weight Rating). The GVWR includes the weight of the vehicle,
all occupants, fuel and cargo...
Categories
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
WARNING
NEVER allow children in the vehicle unattended. The power seats are operable
when the vehicle is turned off.
read more